Before, if dieting and exercise could not get rid of stubborn fat bulges, many patients prefered liposuction, an invasive medical procedure. Or, they considered radio frequency devices or infrared technology, however these devices provided limited improvement. With innovations in technology, patients can now reduce unwanted fat bulges and enjoy permanent decrease in fat cells during a non-invasive, non-surgical method called CoolSculpting that gives dramatic results.
Developed by ZELTIQ Aesthetics, Inc., CoolSculpting can reduce areas which can be difficult to reach with exercise and dieting: love handles, lower belly fat rolls, upper belly fat, muffin top, under bra fat and back fat. It’s an incredibly effective technique that increases the contour from the body.
How is it possible? The FDA-cleared CoolSculpting works via a revolutionary technology called cryolipolysis. During cryolipolysis, literally meaning “cold induced fat destruction,” fat cells are cooled to some temperature which induces those to be eliminated. The process is safe: the temperature required to destroy fat cells is more than what would affect skin, muscle and nerves. With CoolSculpting, there is no injury to the nearby structures.
Throughout the procedure, the physician applies a skin protecting gel pad towards the skin, along with a CoolSculpting applicator is positioned on the desired treatment area. The product draws the fat bulge in, and cools down the fat to induce cryolipolysis, continuously monitoring the temperature and adjusting it as needed.
Unlike liposuction, wherein the fat cells are suctioned from the body, the CoolSculpting treatment causes your body to naturally eliminate the fat cells through the lymphatic drainage system. The cells are then slowly excreted from the body over a duration of the following a few months.
With CoolSculpting, management of each fat bulge often takes 1 hour to do. Love handles may take 2 to 4 hours of treatment; the lower abdomen typically takes about 60 minutes using a special larger applicator. However, each case differs the patient/physician should discuss this before the procedure.
As opposed to liposuction, no anesthesia is necessary for CoolSculpting. Through the procedure, patients can even use their telephone or laptop, read a book or watch a movie. The sole discomfort patients may feel while undergoing CoolSculpting is a sensation of somebody pinching or squeezing the fat when the system is first put on the skin. This usually goes away completely inside the first a few minutes from the procedure.
CoolSculpting can be practiced inside the comfort of a physician’s office. Patients go home right after the process and can resume regular activities; many have already been proven to work out or do yoga the same day. There may be some mild discomfort in the community of treatment; numbness is generally present afterward and can take weeks to solve. Extra Strength Tylenol® can be taken but it’s advised to avoid taking anti-inflammatory agents for that first couple of months following the procedure.
Many patients start noticing results as soon as 3 weeks following the CoolSculpting procedure. A lot of the results will likely be seen at about sixty days after CoolSculpting is performed; improvement may continue after 90 days.
Typically, your skin is elastic enough to contract following the treatment. However, it’s essential to know that if loose skin is the cause of the bulge, then CoolSculpting alone is not going to treat the condition – a surgical procedure such as a tummy tuck may be needed.
Many patients ask if you have a requirement to start out a whole new diet or workout program after CoolSculpting. There exists not. It’s recommended that patients retain the same program they did prior to the procedure to ixpetw how much they weigh.
Most sufferers only need one CoolSculpting treatment; however, repeat treatments can be practiced after three months if additional reduction of the fat bulges is desired. Coolsculpting Before and After Photos show the outcomes of coolsculpting are impressive and undeniable.